Digipro ptt switch manual#
Digipro ptt switch free#

It may be hung on the hook shown attached to the operating table or held in the lap during the QSO. I use a hand-held switch attached to the end of a cord connected to the T/R relay system via a 1/4' phone jack.

With a boom stand, the mic is out of the way and off the desk, but this requires a separate switch for the T/R function. The foot switch is just as cumbersome, requiring one to assume a sometimes awkward position in the chair to operate the switch. A switch on the transmitter panel or station console means reaching, perhaps across the desk, over to the switch each time. A desk stand mic, such as the popular D-104 G-stand, not only gets in the way on the operating table it's only a matter of when, not if, it will accidentally be knocked off the table for the inevitable tumble to the floor. With a hand mic, the microphone has to be held up to the mouth with the transmit button squeezed for the duration of every transmission. Works GREAT! Nice long cord allows it to move around the desk.Д«est part IMO: unlike other switches, you don't have to 'hold it in your hand' - it just sits flat. The yellow/green pair are all that are needed for the big PTT button.

Digipro ptt switch manual#

Secondly, it comes with no manual at all - so you'll need to just meter things. No big deal - I don't need the LED anyway. Just note two things: the red/black power leads are for the LED - HOWEVER the switch unit does NOT include a current-limiting resistor!! I applied 5vdc and ZAP went the LED It obviously expects that to be provided by the computer board - which makes sense, in that the leads would be current-limited leaving the board. But you could just as easily add a 1/4' mono audio plug to plug into your PTT adapter etc. I just snipped the green and yellow wires (ID'd via VOM) and ran to an RCA plug for the back of my Yaesu. It's designed for computer use, to add a power switch, power LED, and reset switch to a desktop unit instead of in the computer tower. While searching for a suitable button to put in a box, I found this awesome little desktop 'computer power switch' on Amazon for $9 that perfectly fills the bill. While I've used a Heil HS3 hand PTT switch for several years, as well as an FS3 footswitch, I wanted something more akin to a desktop mic button like on the Yaesu MD-100 and many others.

Digipro ptt switch free#

Certain Reduced or Free Shipping offers are not valid when certain over-sized items are included in your cart, and some of these offers may not be applicable to APO / FPO / DPOs.I just added a mic boom to my new station. The Shippers used for these offers is at the discretion of Marv Golden Pilot Supplies. These Special Shipping Offers are valid on select items and subject to availability and may change without notice.

Ground Shipping вЂ“ certain items can only be shipped via Ground Shipping and only to the contiguous 48 United States. Other items in cart may be included in this special shipping but this is at our discretion. Certain over-sized or other items may be excluded from this offer.ДЇree Global Shipping вЂ“ when you purchase this item, it will ship free in most places that we ship to outside of the U.S. Shipping destinations and select territories. Usually sent via a ground shipping service. Order Ships Free вЂ“ when you purchase this item, your entire order will ship for free.